TOX PRESSOTECHNIK
ID: +60 3 80231448

News and blog

Back

Fits almost every time

11/11/2020
  • CMB-Bow without drive and all additional parts
    Zoom
    CMB-Bow without drive and all additional parts
  • CMB-Bow with TOX®-ElectricDrive
    Zoom
    CMB-Bow with TOX®-ElectricDrive
  • CMB-Bow with TOX®-Powerpackage
    Zoom
    CMB-Bow with TOX®-Powerpackage

TOX® PRESSOTECHNIK standardizes CMB press frames

In order to achieve faster delivery times, TOX® PRESSOTECHNIK has standardized its range of CMB press frames. They are used for manual as well as automated processes and are often just part of a production line. Despite their slim design, they are highly torsion-resistant and rigid, and thus ideally suited to forming, straightening, bending, pressing and stamping. Compared to special frames, which must be customized in their design, planning and production, the delivery time of the standard version reduces by around 50 percent.

 

There are 3 versions of the new CMB frames, and they are designed for press forces between 10 and 320 kilonewton: CMB 050, CMB 160, CMB 320. The throat depth is 200 millimetres, the opening is determined by the tool coupling and measures 430 millimetres. This is sufficient for a maximum stroke of 200 millimetres.

 

TOX® PRESSOTECHNIK has developed the new standard frames for all relevant TOX® drives for an optimum cost/performance ratio and an installation effort which is as low as possible. The frames can be equipped with the electromechanical servo drive TOX®-ElectricDrive, the pneumohydraulic TOX®-Powerpackage or with the TOX®-Hydraulic Cylinder. Hole patterns on all sides of the CMB frames can be used for pneumatic plates, valves, sensors, restraint devices or for other installations, without the frame needing to be reworked subsequently. TOX® PRESSOTECHNIK supplies fully mounted assemblies with the new press frame coordinated upfront. This also reduces the time needed until commissioning. The new standard frames are available individually or in a package with suitable drive and accessories with immediate effect.

Our customers are our reference
  • Logo Audi
  • Logo AWL
  • Logo Blum
  • Logo BMW
  • Logo Bosch
  • Logo Brose
  • Logo BSH
  • Logo Comau
  • Logo Continental
  • Logo EBM Papst
  • Logo Electrolux
  • Logo Faurecia
  • Logo FFT
  • Logo GM
  • Logo Hettich
  • ifm Tettnang, Kunde von TOX PRESSOTECHNIK
  • Logo KUKA
  • Logo Mercedes Benz
  • Logo Opel
  • Logo SEAT
  • Logo VDH
  • Logo VW
  • Logo Whirlpool
  • Logo ZF

Address

TOX® PRESSOTECHNIK Sdn Bhd
Lot 834, Persiaran Subang
47600 Subang Jaya, Selangor
Phone: +60 3 80231448
Fax: +60 3 80235448
Contact
ID: +60 3 80231448 Contact form
©TOX® PRESSOTECHNIK GmbH & Co.KG
 
Cookie Information

We use cookies to give you the best possible experience when using our website. You can block or regulate the use of cookies by adjusting your browser settings accordingly.